Boon Ripple Blue Bath Mat: Non-Slip Setup and Care Tips
By Babies R Us Australia | Published: 2026-11-05
Category: Guías prácticas
A practical guide to installing and caring for the Boon Ripple Blue Bath Mat, with steps that keep the suction surface gripping and bath time safer for babies and toddlers.
Quick answer
Press the Boon Ripple Blue Bath Mat onto a completely clean, wet tub floor before adding water, then lift and rinse it after every bath. A mat only stays non-slip when the tub and suction cups are free of soap film and the mat is allowed to dry flat.
Why the tub surface matters more than the mat
Suction only works when the cup can push air out against a smooth, wet surface. Textured or curved tub floors, or a film of soap or oil, let the cup lift at the edges. Clean the floor with a soft cloth and plain water, then wet it again before pressing the mat down. If your tub has a heavy slip-resistant texture, test one corner first; the mat may not seal as firmly as it does on a smooth base.
When a bath mat is not enough on its own
The Boon Ripple Blue Bath Mat is designed for babies and toddlers aged 0 to 3 years, but it does not replace a hand on your child. Keep a towel within reach, never leave a baby unattended in the bath, and lift the mat out when the bath is not in use so it cannot trap water underneath. If the mat lifts easily during a bath, stop using it until it grips again.
How to install, check, and clean the mat
- Clean and wet the tub floor: Wipe the base of the bath with a soft cloth and plain water to remove soap film, then leave the surface visibly wet. Common mistake: pressing the mat onto a dry tub, which stops the suction cups sealing. Check that the whole area under the mat is smooth and wet before you place it.
- Press from the centre outward: Lay the mat ripple-side up, start at the middle, and push each suction cup down firmly toward the edges. Common mistake: dropping the mat in and stepping on it, which leaves trapped air under the cups. Run your hand over the mat and feel for any cup that has not flattened.
- Do a lift test before bath time: With the bath empty, tug gently at each corner and along the edges. If any part lifts, peel the mat back, rewet the tub, and press that section down again. Common mistake: adding water first and assuming the mat will settle. A mat that lifts on an empty tub will lift more once your child moves on it.
- Rinse and lift after every bath: Peel the mat up by a corner, rinse both sides under warm water, and shake off excess water. Common mistake: leaving the mat stuck down while the bath drains, which lets soapy water sit under the suction cups. Lift the mat every time, even when the bath looked clean.
- Dry flat and store separately: Lay the mat flat to dry, or hang it over the side of the bath with the suction cups facing out, until it is completely dry. Common mistake: folding or stacking the mat while damp, which traps moisture in the ripples. Store the mat only once the cups and the ripple surface feel dry to the touch.
- Deep clean when the surface feels slippery: If the mat still feels slick after rinsing, wash it with mild soap and warm water, rinse thoroughly, and dry it flat. Common mistake: using harsh cleaners or abrasive scrubbing, which can damage the suction cups. Re-test the suction after every deep clean before your child uses the bath again.
Product facts
- Boon Ripple Blue Bath Mat: The Boon Ripple Blue Bath Mat has a textured ripple pattern and is intended for bath safety as a non-slip surface for babies aged 0 to 3 years. The texture gives small feet something to grip, but it also means the mat needs rinsing between the ripples so soap residue does not build up.
Boon Ripple Blue Bath Mat
